平面波输入下海水-海床-结构动力相互作用分析

海洋工程结构的地震反应分析是保证海洋工程结构地震安全的重要环节.由于其所处的复杂环境, 该问题涉及到流固耦合和土-结相互作用.本文基于海水、饱和海床、基岩流固耦合统一计算框架,采用Davidenkov模型和修正的Masing准则考虑饱和海床的非线性,在脉冲SV波垂直入射下, 进行了海域场地和海洋工程结构的动力响应分析. 首先,对比分析了线性自由场和非线性自由场输入情形的海域场地非线性反应,结果表明线性自由场输入时反应不合理,自由场分析和场地分析应该采用相一致的本构模型. 然后,对比分析了海床分别为线性和非线性情形时,海域场地以及海水-海床-结构体系的反应特征. 与线性海床情形相比,非线性对海床反应的影响主要由如下两方面因素控制: 一方面,非线性导致饱和海床模量减小, 饱和海床与基岩间的波阻抗比减小,由基岩到饱和海床间的反射系数和透射系数增加, 导致反应增大; 另一方面,非线性导致阻尼加大, 使海床反应减小. 对于本文算例而言,阻尼对非线性海床结果的影响占主导作用.      

Potts models with magnetic field: Arithmetic,geometry, and computation

We give a sheaf theoretic interpretation of Potts models with external magnetic field, in terms of constructible sheaves and their Euler characteristics. We show that the polynomial countability question for the hypersurfaces defined by the vanishing of the partition function is affected by changes in the magnetic field: elementary examples suffice to see non-polynomially countable cases that become polynomially countable after a perturbation of the magnetic field. The same recursive formula for the Grothendieck classes, under edge-doubling operations, holds as in the case without magnetic field, but the closed formulae for specific examples like banana graphs differ in the presence of magnetic field. We give examples of computation of the Euler characteristic with compact support, for the set of real zeros, and find a similar exponential growth with the size of the graph. This can be viewed as a measure of topological and algorithmic complexity. We also consider the computational complexity question for evaluations of the polynomial, and show both tractable and NP-hard examples, using dynamic programming.     

Dynamic Behaviour in Microcompartments

Compartmentalisation is recognised to be a primary step for the assembly of non-living matter towards the construction of life-like microensembles. To date, a host of hollow microcompartments with various functionalities have been widely developed. Within this respect, given that dynamic behaviour is one of the fundamental features to distinguish living ensembles from those that are non-living, the design and construction of microcompartments with various dynamic behaviours are attracting considerable interest from a wide range of research communities. Significantly, the created dynamic microcompartments could also be widely used as chassis for further bottom-up design towards building protocell models by integrating and booting up necessary biological information. Herein, strategies to install the various motility behaviours into microcompartments, including haptotaxis, chemotaxis and gravitaxis, are summarized in the anticipation of inspiring more designs towards creating various advanced active microcompartments, and contributing new techniques to the ultimate goal of constructing a basic living unit entirely from non-living components.     

Theoretical Design of Biodegradable Phthalic Acid Ester Derivatives in Marine and Freshwater Environments

The biodegradability of phtalic acid esters in marine and freshwater environments was characterized by their binding free energy with corresponding degrading enzymes. According to comprehensive biodegradation effects weights, the binding free energy values were converted into dimensionless efficacy coefficient using ratio normalization method. Then, considering comprehensive dual biodegradation effects value and the structural parameters of PAEs in both marine and freshwater environments, a 3D-QSAR pharmacophore model was constructed, five PAE derivatives (DBP−COOH, DBP−CHO, DBP−OH, DINP−NH₂, and DINP−NO₂) were screened out based on their environmental friendliness, functionality and stability. The prediction of biodegradation effects on five PAE derivatives by biodegradation models in marine and freshwater environment increased by 15.90 %, 15.84 %, 27.21 %, 12.33 %, and 8.32 %, and 21.57 %, 15.21 %, 20.99 %, 15.10 %, and 9.74 %, respectively. By simulating the photodegradation path of the PAE derivative molecular, it was found that DBP−OH can generate ^.OH and provides free radicals for the photodegradation of microplastics in the environment.     

Screening gas-phase chemical kinetic models: Collision limit compliance and ultrafast timescales

Detailed gas-phase chemical kinetic models are widely used in combustion research, and many new mechanisms for different fuels and reacting conditions are developed each year. Recent works have highlighted the need for error checking when preparing such models, but a useful community tool to perform such analysis is missing. In this work, we present a simple online tool to screen chemical kinetic mechanisms for bimolecular reactions exceeding collision limits. The tool is implemented on a user-friendly website, cloudflame.kaust.edu.sa, and checks three different classes of bimolecular reactions; (ie, pressure independent, pressure-dependent falloff, and pressure-dependent PLOG). In addition, two other online modules are provided to check thermodynamic properties and transport parameters to help kinetic model developers determine the sources of errors for reactions that are not collision limit compliant. Furthermore, issues related to unphysically fast timescales can remain an issue even if all bimolecular reactions are within collision limits. Therefore, we also present a procedure to screen ultrafast reaction timescales using computational singular perturbation. For demonstration purposes only, three versions of the rigorously developed AramcoMech are screened for collision limit compliance and ultrafast timescales, and recommendations are made for improving the models. Larger models for biodiesel surrogates, tetrahydropyran, and gasoline surrogates are also analyzed for exemplary purposes. Numerical simulations with updated kinetic parameters are presented to show improvements in wall-clock time when resolving ultrafast timescales.     

NMR analysis and triad sequence distributions of poly(3-hydroxybutyrate-co-3-hydroxyvalerate)

Polyhydroxyalkanoates (PHAs) are considered promising “green” alternatives to synthetic polymers because they are bio-derived, biodegradable and biocompatible. The properties of bacterial PHA copolymers depend on their microstructures, which can be modified with the use of different fermentation processes and feed materials. Thus, it is desirable to have an improved testing method for the determination of PHA microstructures. In this work, a detailed NMR analysis of poly(3-hydroxybutyrate-co-3-hydroxyvalerate) microstructure was made. Previously only two of the hydroxyvalerate ¹³C NMR peaks have been assigned at the triad level. In this work, three of the ¹³C hydroxyvalerate peaks and two of the hydroxybutyrate peaks were found to be split into four peaks each due to comonomer sequence effects. Using eight copolymer samples with a wide compositional range, we were able to assign all these peaks to B-centered and V-centered triad sequences. Through curve deconvolution, the triad intensities were determined. These triad sequence intensities can then be analyzed via both the first-order Markovian and two-component Bernoullian models to obtain more in-depth information on copolymer composition and comonomer reactivities.     

Collective risk models with dependence

In actuarial science, collective risk models, in which the aggregate claim amount of a portfolio is defined in terms of random sums, play a crucial role. In these models, it is common to assume that the number of claims and their amounts are independent, even if this might not always be the case. We consider collective risk models with different dependence structures. Due to the importance of such risk models in an actuarial setting, we first investigate a collective risk model with dependence involving the family of multivariate mixed Erlang distributions. Other models based on mixtures involving bivariate and multivariate copulas in a more general setting are then presented. These different structures allow to link the number of claims to each claim amount, and to quantify the aggregate claim loss. Then, we use Archimedean and hierarchical Archimedean copulas in collective risk models, to model the dependence between the claim number random variable and the claim amount random variables involved in the random sum. Such dependence structures allow us to derive a computational methodology for the assessment of the aggregate claim amount. While being very flexible, this methodology is easy to implement, and can easily fit more complicated hierarchical structures.     

Boundary value problems for a quasilinear parabolic equation with an unknown coefficient

The work is connected with the mathematical modeling of physical–chemical processes in which inner characteristics of materials are subjected to changes. The considered nonlinear parabolic models consist of a boundary value problem for a quasilinear parabolic equation with an unknown coefficient multiplying the derivative with respect to time and, moreover, involve an additional relationship for a time dependence of this coefficient. For such a system, conditions of unique solvability in a class of smooth functions are studied on the basis of the Rothe method. The proposed approach involves the proof of a priori estimates in the difference-continuous Hölder spaces for the corresponding differential-difference nonlinear system that approximates the original system by the Rothe method. These estimates allow one to establish the existence of the smooth solutions and to obtain the error estimates of the approximate solutions.As examples of applications of the considered nonlinear boundary value problems, the models of destruction of heat-protective composite under the influence of high temperature heating are discussed.     

Analysis of risk bounds in partially specified additive factor models

The study of worst case scenarios for risk measures (e.g. the Value at Risk) when the underlying risk vector (or portfolio of risks) is not completely specified is a central topic in the literature on robust risk measurement. In this paper we discuss partially specified factor models as introduced in Bernard et al. (2017) in more detail for the class of additive factor models which admit more explicit results. These results allow to describe in more detail the reduction of risk bounds obtainable by this method in dependence on the degree of positive resp. negative dependence induced by the systematic risk factors. The insight may help in applications of this reduction method to get a better qualitative impression on the range of influence of the partially specified factor structure.     

An interview with Sam C. Saunders

Sam C. Saunders, the son of Elizabeth Cundiff and Winston E. Saunders, was born in Richland, OR, on February 24, 1931. The family moved to La Grande, OR, in 1944, where Sam completed high school and two years at Eastern Oregon College. He then received the BSc degree in Mathematics from the University of Oregon, Eugene, OR, in 1952, and he attended the University of Washington, Seattle, WA, receiving a PhD degree under Z. W. Birnbaum. After graduating, he accepted employment at the Boeing Company in its Mathematical Services Unit and, in 1972, a position as a Full Professor at Washington State University, Pullman, WA, from which he retired in 1996.